FixVault
Home › Infiniti › 2013 › M35h › Repair and Diagnosis › External Pages › Different car › Section 30 (Brake System) › DTC/Circuit Diagnosis › Brake Warning Lamp › Component Function Check

Component Function Check

WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK BRAKE WARNING LAMP FUNCTION (1)

    Check that brake warning lamp turns ON for approximately several second after ignition switch is turned ON.

    CAUTION: Never set the vehicle to READY/Never start the engine.

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Proceed to "DIAGNOSIS PROCEDURE ".

  2. CHECK BRAKE WARNING LAMP FUNCTION (2)

    Check that brake warning lamp in combination meter turns ON or OFF when brake fluid level switch is operated while brake fluid level in reservoir tank is at the specified level.

    NOTE: Brake warning lamp turns ON when brake fluid is less than the specified level (when brake fluid level switch is ON).

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Check brake fluid level switch system. Refer to "DIAGNOSIS PROCEDURE ".

About FixVault