FixVault
Home › Infiniti › 2013 › QX56 AWD › Repair and Diagnosis › External Pages › Different car › Section 359 (Engine Control System - Component Testing (Except CROSSCABRIOLET)) › ASCD Brake Switch › Component Function Check

Component Function Check

WARNING: This page is about a different car, the 2013 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ASCD BRAKE SWITCH FUNCTION 

    With CONSULT 

    1. Turn ignition switch ON.
    2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
    3. Check "BRAKE SW1" indication under the following conditions.
      Monitor item Condition Indication
      BRAKE SW1 Brake pedal Slightly depressed OFF
      Fully released ON

    Without CONSULT 

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals.
      ECM Condition Voltage
      Connector + -
      Terminal Terminal
      E16 110 (ASCD brake switch signal) 112 Brake pedal Slightly depressed Approx. 0 V
      Fully released Battery voltage

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Go to "DIAGNOSIS PROCEDURE ".

About FixVault