Diagnosis Procedure

1. Disconnect accelerator pedal position (APP) sensor harness connector.
2. Turn ignition switch ON.
3. Check the voltage between APP sensor harness connector and ground.

   APP sensor		Ground	Voltage (V)
   Connector	Terminal
   E110 (Without ICC)	2	Ground	Approx. 5
   E67 (With ICC)	12

   Is the inspection result normal? 

   YES: GO TO  6.

   NO: GO TO 2.

Check harness for short to power and short to ground, between the following terminals.

Is the inspection result normal? 

YES: GO TO 3.

NO: Repair short to ground or short to power in harness or connectors.

Check the following.

• Camshaft position sensor (bank 2) (Refer to "COMPONENT INSPECTION (CAMSHAFT POSITION SENSOR) ".)
• Manifold absolute pressure (MAP) sensor (Refer to "COMPONENT INSPECTION (MAP SENSOR) ".)

  Is the inspection result normal? 

  YES: GO TO 4.

  NO: Replace malfunctioning component.

Refer to "COMPONENT INSPECTION (THROTTLE POSITION SENSOR) ".

Is the inspection result normal? 

YES: GO TO  8.

NO: GO TO 5.

Replace electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

: INSPECTION END

Refer to "COMPONENT INSPECTION (ACCELERATOR PEDAL POSITION SENSOR) ".

Is the inspection result normal? 

YES: GO TO  8.

NO: GO TO 7.

Replace accelerator pedal assembly. Refer to "MODELS WITHOUT DISTANCE CONTROL ASSIST SYSTEM: REMOVAL AND INSTALLATION " (Without distance control assist system) or "MODELS WITH DISTANCE CONTROL ASSIST SYSTEM: REMOVAL AND INSTALLATION " (With distance control assist system).

: INSPECTION END

Refer to "INTERMITTENT INCIDENT ".

: INSPECTION END