Inspection Mode 2

WARNING: This page is about a different car, the 2015 Infiniti Q70. However, it is still accessible from the selected car via links, so may be relevant.

CHANGING TO INSPECTION MODE

WITH CONSULT:
1. Turn ignition switch OFF.
2. Select "INSPECTION MODE 2" in "ACTIVE TEST" mode of "EV/HEV".
3. Touch "ON".
4. Set the vehicle to READY.
5. The system changes to inspection mode 2, and the 12-volt battery charge warning lamp on the combination meter blinks.
WITHOUT CONSULT:
1. Perform the following steps within 60 seconds.
  1. Turn ignition switch ON with the selector lever at the P position.
  2. Fully depress the accelerator pedal, then fully release it 3 times.
  3. While depressing the brake pedal, shift the select lever to the N position.
  4. Fully depress the accelerator pedal, then fully release it 3 times.
  5. While depressing the brake pedal, shift the select lever to the P position.
  6. Fully depress the accelerator pedal, then fully release it 3 times.
2. Set the vehicle to READY.
3. The system changes to inspection mode 2, and the 12-volt battery charge warning lamp on the combination meter blinks.
END