Additional Service When Replacing Control Unit: Description
Each function is reset to the following condition when the driver seat control unit is replaced. Refer to SPECIAL REPAIR REQUIREMENT .
| Function | Condition | Procedure |
|---|---|---|
| Memory (Seat, steering, mirror) | Erased | Perform storing |
| Entry/exit assist | OFF | Perform initialization |
| Set slide amount*1 | ||
| Intelligent Key interlock | Erased | Perform storing |
| Seat synchronization | OFF | - |
*1 : Default value is 40 mm.
NOTE:
Notice that disconnecting the battery when detected DTC are present will erase the DTC memory.