Work Procedure
WARNING: This page is about a different car, the 2020 Infiniti Q50. However, it is still accessible from the selected car via links, so may be relevant.
- SAVING VEHICLE SPECIFICATION
CONSULT Configuration
- Select "Re/programming, Configuration".
- Select the operation according to the CONSULT screen.
- Perform "Before ECU Replacement" of "Vehicle Configuration" to write vehicle specification.
NOTE: If "Before ECU Replacement" of "Vehicle Configuration" cannot be used, use the "Manual Configuration" after replacing BCM. Refer to Work Procedure .GO TO 2.
- REPLACE BCM
Replace BCM. Refer to BCM : Removal & Installation .
GO TO 3.
- WRITING VEHICLE SPECIFICATION
Select "Re/programming, Configuration". Refer to Work Procedure .
GO TO 4.
- INITIALIZE BCM (NATS) (IF EQUIPPED)
Perform BCM initialization. (NATS)
WORK END
- INITIALIZE TPMS (IF EQUIPPED)
Perform TPMS initialization.
WORK END