Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect Door Lock Assembly (Driver Side) connect.
3. Turn ignition switch ON.
4. Check voltage between Door Lock Assembly (Driver Side) harness connector and ground.

   (+)		(-)	Voltage (V)
   Door Lock Assembly (Driver Side)
   Connector	Terminal
   D1	5	Ground	4 - 6
   	6

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2. 

1. Turn ignition switch OFF.
2. Disconnect Power Window Main Switch connector.
3. Check continuity between Power Window Main Switch harness connector and Door Lock Assembly (Driver Side) harness connector.

   Power Window Main Switch		Door Lock Assembly (Driver Side)		Continuity
   Connector	Terminal	Connector	Terminal
   D8	15	D1	6	Existed
   	16		5

4. Check continuity between Power Window Main Switch harness connector and ground.

   Power Window Main Switch		(-)	Continuity
   Connector	Terminal
   D8	15	Ground	Not existed
   	16

Is the inspection result normal?

YES 

Replace Power Window Main Switch. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

Check continuity between Door Lock Assembly (Driver Side) harness connector and ground.

Is the inspection result normal?

YES 

GO TO STEP 4. 

NO 

Repair or replace harness.

Check Door Lock Assembly (Driver Side).

Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

Check intermittent incident. Refer to INTERMITTENT INCIDENT .

NO 

Replace Door Lock Assembly (Driver Side). Refer to REMOVAL AND INSTALLATION .