Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect Power Window Motor (Passenger Side) connector.
3. Turn ignition switch ON.
4. Check voltage between Power Window Motor (Passenger Side) harness connector and ground.

   (+)		(-)	Condition		Voltage (V)
   Power Window Motor (Passenger Side)
   Connector	Terminal
   D25	6	Ground	Power Window Sub-Switch	NEUTRAL	0 - 1
   				UP	9 - 16
   	3			NEUTRAL	0 - 1
   				DOWN	9 - 16

Is the inspection result normal?

YES 

Replace Power Window Motor (Passenger Side). Refer to REMOVAL AND INSTALLATION .

NO 

GO TO STEP 2  .

1. Turn ignition switch OFF.
2. Disconnect Power Window Sub-Switch connector.
3. Check continuity between Power Window Sub-Switch harness connector and Power Window Motor (Passenger Side) harness connector.

   Power Window Sub-Switch		Power Window Motor (Passenger Side)		Continuity
   Connector	Terminal	Connector	Terminal
   D21	8	D25	6	Existed
   	9		3

4. Check continuity between Power Window Sub-Switch connector and ground.

   Power Window Sub-Switch		(-)	Continuity
   Connector	Terminal
   D21	8	Ground	Not existed
   	9

Is the inspection result normal?

YES 

Replace Power Window Sub-Switch. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.