FixVault
Home › Infiniti › 2017 › QX70 RWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 4 (Transfer Case) › Unit Disassembly And Assembly › Main Shaft › Disassembly

Main Shaft: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Separate front case and rear case, then remove main shaft assembly. Refer to DISASSEMBLY .
  2. Remove snap ring (1) from main shaft.
    G05979424Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove spacer (1) and steel ball (2) from main shaft.
    G05979425Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Be careful not to drop the steel ball.

  4. Using a press, remove electric controlled coupling from main shaft.
    G05979426Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove circlip (1) from notch (A) of electric controlled coupling.
    G05979441Courtesy of NISSAN NORTH AMERICA, INC.
    ARROW : Front side
    CAUTION:
    • Never remove the circlip from the electric controlled coupling rear side.
    • Never damage electric control coupling spline, bush, etc.
  6. Remove snap ring from main shaft.
  7. Remove spacer (1) and steel ball (2) from main shaft.
    G05979428Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Be careful not to drop the steel ball.

  8. Remove sprocket from main shaft.
  9. Remove needle bearing from main shaft.
About FixVault