FixVault
Home › Infiniti › 2017 › QX80 Base, AWD › Repair and Diagnosis › Steering › Steering Column › Steering System › Removal And Installation › Power Steering Oil Pump › Disassembly And Assembly › Disassembly

Disassembly And Assembly: Disassembly

CAUTION:
  • Fix oil pump with a vise if necessary.
  • Use copper plates when fixing with a vise.
  1. Perform inspection before disassembly. Refer to INSPECTION .
  2. Remove rear cover mounting bolts, and then remove rear cover from body assembly.
  3. Remove gasket from body assembly.
  4. Remove dowel pin, cartridge and side plate from body assembly.
  5. Remove pulley mounting nut and washer, then remove pulley from drive shaft.
  6. Remove snap ring from drive shaft and press out it.
    G04076796Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    When removing snap ring, be careful not to damage drive shaft.

  7. Remove oil seal from body assembly using a suitable tool.
  8. Remove O-ring from body assembly.
  9. Remove mounting bolts of suction pipe, and then remove suction pipe and bracket from body assembly.
  10. Remove connector bolt, and then remove O-ring, flow control valve and spring from body assembly
  11. Perform inspection after disassembly. Refer to INSPECTION .
About FixVault