FixVault
Home › Infiniti › 2018 › QX30 Base › Repair and Diagnosis › External Pages › Different car › Section 60 (Chassis Control) › Chassis Control › DTC/Circuit Diagnosis › C1BBA-00 Control Module › DTC Description › DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 

    SYMBOL With CONSULT

    1. Turn the ignition switch OFF to ON.
      CAUTION: Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
    2. Perform self-diagnosis for "CHASSIS CONTROL".

    Is DTC "C1BBA-00" detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

About FixVault