Precautions for Chassis control

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.

Never disassemble the chassis control module.
The parts must not be reused if they are dropped.
When using a free roller, never activate the active lane control function.
Never perform ACTIVE TEST while driving the vehicle.
Slight vibrations are felt on the brake pedal and the operation noises occur, when active trace control function operates. This is not a malfunction because it is caused by active trace control function that is normally operated.
Active trace control function, active lane control function, LDP function, LDW function, blind spot intervention function, and digital motion control function are not always activated in any driving conditions.
User registration information is all reset when the display control unit is replaced.
When a Log-in function related part is replaced, information about the replaced part is reset. Refer to Log-in Function .
When starting the vehicle or stopping the engine during Log-in function change, the operation results may not be reflected. Refer to Log-in Function .
After an Infiniti drive mode selector related part is replaced, operate the drive mode select switch to check that the indication of the information display positioned in the combination meter changes. Refer to Work Flow .
After replace the chassis control module, depress brake pedal and check that the stop lamp turns ON.