FixVault
Home › Infiniti › 2018 › QX30 Base › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Transfer Case) › Basic Inspection › Additional Service When Replacing Gear Oil › Work Procedure

Work Procedure

WARNING: This page is about a different variant/trim than selected.
  1. RESETTING OIL SERVICE DATA 

    SYMBOL With CONSULT

    1. Turn the ignition switch OFF to ON.
    2. Select "Resetting oil service data" in "WORK SUPPORT" for "ALL MODE AWD/4WD".
    3. Select "Start".
    4. Follow the instructions in CONSULT.
    5. Check that "Reset" is displayed.

    GO TO 2.

  2. FUNCTION TEST OF AWD SOLENOID 
    NOTE: When performing function test of AWD solenoid, driving situation is required.

    SYMBOL With CONSULT

    1. Turn the ignition switch OFF to ON.
    2. Select "Function test of solenoid valve while driving" in "WORK SUPPORT" for "ALL MODE AWD/4WD".
    3. Select "Start".
    4. Follow the instructions in CONSULT.
      NOTE: When performing actuation, a brief jolt must be felt in the vehicle; this ensures that the entire final drive assembly is correctly filled with oil.

    Is "successful" displayed?

    YES

    WORK END

    NO

    GO TO 3.

  3. FUNCTION TEST OF AWD SOLENOID AGAIN 

    SYMBOL With CONSULT

    Perform "Function test of solenoid valve while driving" again.

    Is "successful" displayed within 10 times?

    YES

    WORK END

    NO

    GO TO 4.

  4. CHECKING OIL LEVEL 

    Check oil level. Refer to Inspection .

    GO TO 2.

About FixVault