Work Procedure

SAVING VEHICLE SPECIFICATION
With CONSULT
1. Turn ignition switch ON.
2. Select "MULTI AV" of "Re/programming, Configuration" with CONSULT.
3. Select "Before ECU Replacement" of "Read / Write Configuration", and save or print the current vehicle specification. Refer to Description .
  NOTE: If "Before ECU Replacement" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing display control unit to write vehicle specification.
GO TO 2.
REPLACE DISPLAY CONTROL UNIT
1. Turn ignition switch OFF.
2. Replace display control unit. Refer to Removal and Installation .
GO TO 3.
WRITING VEHICLE SPECIFICATION
With CONSULT
1. Turn ignition switch ON.
2. Select "MULTI AV" of "Re/programming, Configuration" with CONSULT.
3. Select "After ECU Replacement" of "Read / Write Configuration", and write the vehicle specification into the display control unit. Refer to Description .
GO TO 4.
OPERATION CHECK
Confirm that display control unit operates normally.

Work End.