DTC Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect A/T assembly harness connector terminal and ground.

   +		-	Condition	Voltage
   A/T assembly
   Connector	Terminal
   F2	2	Ground	Always	9 - 16 V

Is the inspection result normal?

YES

Replace the control valve & TCM. Refer to CONTROL VALVE WITH TCM : Removal & Installation .

NO

GO TO 2..

Check the following items:

• Open circuit or short circuit in harness between battery positive terminal and A/T assembly harness connector terminal 2.
• 10 A fuse (No. 68)

Is the inspection result normal?

YES

Check intermittent incident. Refer to Inspection .

NO

Repair or replace damaged parts.