Work Procedure

Perform the following procedures after replacing the around view monitor control unit:

1. REPLACE AROUND VIEW MONITOR CONTROL UNIT 

   Replace around view monitor control unit. Refer to Removal and Installation .

   GO TO 2.

2. WRITING MAC KEY 

   Perform MAC key writing. Refer to Description .

   GO TO 3.

3. PERFORM CONFIGURATION 
   CAUTION: Always write the MAC key before writing the around view monitor control unit configuration.

   Perform configuration. Refer to Description .

   GO TO 4.

4. WRITING OF CALIBRATION DATA 

   Write the calibration data stored in the camera. Refer to Work Procedure .

   GO TO 5.

5. PERFORM SELF-DIAGNOSIS 

   CONSULT

   1. Select "Self Diagnostic Result" mode of "AVM".
   2. Check if any DTCs are detected.

   Are any DTCs detected?

   YES

   Perform the trouble diagnosis for the detected DTC. Refer to DTC Index .

   NO

   GO TO 6.

6. OPERATION CHECK 

   Confirm that the operation of the intelligent around view monitor and the camera image (reference line, expected route) are normal.

   Work End.