Application Items
CONSULT performs the following functions via CAN communication using ADAS control unit 2.
|
Diagnosis mode |
CGW Status |
Description |
||
|
Restricted Mode |
Diag Test Mode |
Open Mode |
||
|
Self Diagnostic Result |
Display |
Display |
Display |
Retrieve DTC from ECU and display diagnostic items |
|
CGW Information *1 |
Display *1 |
Display *1 |
Display *1 |
|
|
Data Monitor |
Display |
Display |
Display |
Monitor the input/output signal of the control unit in real time |
|
Work Support *1 |
Non-display *1 |
Non-display *1 |
Display *1 |
This mode enables a technician to adjust some devices faster and more accurately |
|
Active Test *1 |
Non-display *1 |
Display *1 |
Display *1 |
|
|
ECU Identification |
Display |
Display |
Display |
Display the ECU identification number (part number etc.) of the selected system |
|
Configuration *2 |
Display |
Display |
Display |
The vehicle specification can be written when the control unit is replaced |
|
Network-DTC *2 |
Display |
Display |
Display |
Display network DTC which the control unit memorizes when performing "Diagnosis (All System)". |
|
MAC Diagnosis *2 |
Display |
Display |
Display |
Display MAC diagnosis result divided into the following two inspection priorities.
|
|
CAN Diag Support Monitor *2 |
Display |
Display |
Display |
It monitors the status of CAN communication |
*1: In some vehicles, it is not malfunctioning in case of no display of "CGW Information". In this case, it is not necessary to switch the CGW status. In vehicles where "CGW information" is not displayed, "Work Support" and "Active Test" are always displayed.
*2: Displays when performing "Diagnosis (All System)".