Work Procedure
- The ignition battery saver system can be temporarily disabled, without using CONSULT, to prevent it from functioning when performing trouble diagnosis.NOTE: When ignition battery saver is disabling, the operation of push-button ignition switch is not accepted for less than 2 seconds.
- To resume ignition battery saver system, press and hold the push-button ignition switch continuously for 3 seconds or more when all of the following conditions are satisfied. (Ignition switch ON -> OFF):
- Selector lever: Except P or N position
- Brake pedal: Not depressed
- WORK PROCEDURE
- Ignition switch OFF.
- Without depressing the brake pedal, press the push-button ignition switch.
- With depressing the brake pedal, shift the selector lever in another position except P or N.
- Without depressing the brake pedal, press and hold the push-button ignition switch continuously for 3 seconds or more.
- Shift the selector lever to P position to stop the P position warning (buzzer).NOTE: If you are not concerned about the P position warning (buzzer) volume and battery discharge, this is not a necessary step.
YES
Work End.