Component Inspection

1. Turn ignition switch OFF.
2. Disconnect combination switch (spiral cable) harness connector M302.
3. Check resistance between combination switch harness connector terminals under the following conditions.

   Combination switch		Condition	Resistance (Ohm)
   Connector	Terminals
   M302	13 and 16	MAIN switch: Pressed	Approx. 0
   		DYNAMIC DRIVER ASSISTANCE switch: Pressed	Approx. 270
   		CANCEL switch: Pressed	Approx. 620
   		DISTANCE switch: Pressed	Approx. 1, 100
   		SET- switch: Pressed	Approx. 1, 810
   		RES+ switch: Pressed	Approx. 3, 000
   		All ICC steering switches: Released	Approx. 5, 420

Is the inspection result normal?

YES

INSPECTION END

NO

Replace ICC steering switch. Refer to STEERING WHEEL : Removal & Installation .