Work Procedure
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Fully understand the following items well before the road test;
- Precautions: Refer to Precaution for Blind Spot Warning/Blind Spot Intervention System Service .
- System description for Blind Spot Warning: Refer to System Description .
- System description for Blind Spot Intervention: Refer to System Description .
- LDW/LDP SYSTEM ACTION TEST
Perform the LDW/LDP system action test. Refer to Inspection Procedure .
GO TO 2.
- CHECK BSW SYSTEM SETTING
- Start the engine.
- Check that the BSW system setting can be enabled/disabled on the integral switch.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO 3.
- BSW SYSTEM ACTION TEST
- Enable the setting of the BSW system on the integral switch.
- Turn warning systems switch ON (warning systems ON indicator is ON).NOTE: Blind Spot Intervention system is OFF.
- Check BSW operation according to the following table.
Vehicle condition/ Driver's operation
Action
Vehicle speed
(Approx.)
[km/h (MPH)]
Turn signal condition
Status of vehicle detection within detection area
Indication on the
Blind Spot Warning/Blind Spot Intervention indicator
Indication on the combination meter
Indicator color
Buzzer
Less than approx.
32 (20)
--
--
OFF
White
OFF
Approx.
32 (20)
or more
--
Vehicle is absent
OFF
White
OFF
OFF
Vehicle is detected
ON
White
OFF
ON
(vehicle detected direction)
Before turn signal operates
Vehicle is detected
Blink
Yellow (Blink)
Short continuous beeps
Vehicle is detected after turn signal operates
Blink
Yellow (Blink)
OFF
GO TO 4.
- CHECK BLIND SPOT INTERVENTION SYSTEM SETTING
- Start the engine.
- Check that the Blind Spot Intervention system setting can be enabled/disabled on the integral switch.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO 5.
- CHECK WARNING SYSTEM SWITCH
- Start the engine.
- After starting the engine wait for 5 seconds or more.
- Enable the setting of the Blind Spot Intervention system on the integral switch.
- Press the warning system switch.
- Check that the Blind Spot Intervention ON indicator on the combination meter illuminates.
- Check that the Blind Spot Intervention ON indicator turns OFF when the system is turned OFF by pressing the warning system switch.
- Check that the Blind Spot Intervention ON indicator turns OFF when the engine starts again.
NOTE:- The Blind Spot Intervention ON indicator does not illuminate even when the warning system switch is turned ON within approximately 5 seconds after starting the engine.
Inspection End.