Work Procedure

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;
- Precautions:
- System description for TSR: Refer to System Description .
- Handling precaution: Refer to Precautions for Traffic Sign Recognition .

CHECK TSR SYSTEM SETTING
1. Start the engine.
2. After starting the engine wait for 30 seconds or more.
3. Enable the setting of the TSR system on the combination meter.
4. Turn OFF the ignition switch and wait for 5 seconds or more.
5. Check that the previous setting is saved when the engine starts again.
GO TO 2.

ACTION TEST FOR LDW

Enable the setting of the TSR system on the combination meter.

Check the TSR operation according to the following table.

System status	Condition	Display on combination meter
System status	Condition	Upper part	Middle part
TSR OFF	--	--	Courtesy of NISSAN NORTH AMERICA, INC.
TSR ON	Road sign not detected	--	Courtesy of NISSAN NORTH AMERICA, INC.
	Road sign detected (except for speed limit signs)	--	This is an example. For details of displayed signs, refer to System Description Courtesy of NISSAN NORTH AMERICA, INC.
	Road sign detected (Speed limit signs)	This is an example. For details of displayed signs, refer to System Description Courtesy of NISSAN NORTH AMERICA, INC.	This is an example. For details of displayed signs, refer to System Description Courtesy of NISSAN NORTH AMERICA, INC.

INSPECTION END