Work Procedure

Perform the following procedures after replacing the around view monitor control unit:

1. REPLACE AROUND VIEW MONITOR CONTROL UNIT 
   1. Replace around view monitor control unit. Refer to Removal and Installation .

   >>

   GO TO 2.

2. WRITING MAC KEY 
   1. Perform MAC key writing. Refer to Description .

   >>

   GO TO 3.

3. PERFORM CONFIGURATION 
   CAUTION:

   Always write the MAC key before writing the around view monitor control unit configuration.

   1. Perform configuration. Refer to Description .

   >>

   GO TO 4.

4. WRITING OF CALIBRATION DATA 
   1. Write the calibration data stored in the camera. Refer to Work Procedure .

   >>

   GO TO 5.

5. PERFORM SELF-DIAGNOSIS 
   1. CONSULT
      1. Select "Self Diagnostic Result" mode of "AVM".
      2. Check if any DTCs are detected.

   Are any DTCs detected?

   YES>>

   Perform the trouble diagnosis for the detected DTC. Refer to DTC Index .

   NO>>

   GO TO 6.

6. OPERATION CHECK 
   1. Confirm that the operation of the intelligent around view monitor and the camera image (reference line, expected route) are normal.

   >>

   Work End.