FixVault
Home › Infiniti › 2023 › QX60 Autograph, AWD › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel System › Removal And Installation › EVAP Control System Pressure Sensor › Removal and Installation

Removal and Installation

REMOVAL 

  1. Remove the floor under cover (LH). Refer to Removal and Installation .
  2. Disconnect the harness connector from EVAP canister control pressure sensor.
  3. Remove EVAP canister control pressure sensor and O-ring.

INSTALLATION 

Installation is in the reverse order of removal.

CAUTION:

Do not reuse O-ring when installing new EVAP canister control pressure sensor. The EVAP canister control pressure sensor and O-ring are serviced as an assembly.

About FixVault