Symptom Table

CONSULT

1. Select "Data Monitor" to check for any malfunctioning item.
2. Check that the data monitor display switches in conjunction with the combination switch operation.
3. If there is a switch whose display does not change, specify the applicable combination switch circuit (INPUT 1 - 6 and OUTPUT 1 - 6) using the combination switch circuit confirmation table for the circuit used for that switch.
   NOTE: Since combination switch circuits are shared with multiple switches, if the switches used other than the defective switch are normal, the combination switch circuit can be determined to be normal.

   Example: If the circuit used for the switch corresponds to INPUT 1 and OUTPUT 2 of the combination switch circuit, but the other switches that use the INPUT 1 circuit are normal, it is determined that the INPUT 1 circuit is normal and inspection OUTPUT 2 circuit. If other switches that use OUTPUT 2 circuit are normal, the combination switch circuit (INPUT 1 and OUTPUT 2) is determined to be normal, and it can be determined that the combination switch is defective.

   Circuit used: x

   Combination switch circuit confirmation table
   
   

   Data monitor item	Combination switch circuit
   	INPUT 1	INPUT 2	INPUT 3	INPUT 4	INPUT 5	INPUT 6	OUTPUT 1	OUTPUT 2	OUTPUT 3	OUTPUT 4	OUTPUT 5	OUTPUT 6
   Check diode 1	x						x
   High beam switch	x							x
   Passing switch	x								x
   Front fog switch	x										x
   INT volume 1		x					x
   Check diode 2		x						x
   Low beam switch		x							x
   AUTO light switch		x								x
   Tail lamp switch		x									x
   Front washer switch			x				x
   Rear washer switch			x					x
   Check diode 3			x						x
   Turn signal LH			x							x
   Turn signal RH			x								x
   Front wiper LO				x			x
   Front wiper HI				x				x
   Front wiper INT				x					x
   Check diode 4				x						x
   Light OFF switch				x							x
   INT volume 2					x		x
   INT volume 3					x			x
   Rear wiper INT					x				x
   Rear wiper ON					x					x
   Check diode 5					x						x
   Front wiper OFF						x	x
   Front wiper MIST						x		x
   Check diode 6						x						x

4. Identify the possible malfunctioning part from the combination switch circuit confirmation table and inspect or replace it.

   Possible malfunction part / Symptom		Inspection / Replace
   Some data monitor displays do not switch	There is a malfunction with either of the combination switch INPUT circuits	Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
   	There is a malfunction with either of the combination switch OUTPUT circuits	Inspect the combination switch output circuit applicable to the malfunctioning part. Refer to Diagnosis Procedure .
   	It is not applicable to any of the combination switch INPUT and OUTPUT circuits	Replace combination switch. Refer to Removal and Installation . If the data monitor display does not switch for a specific switch, the corresponding switch has a malfunction.Removal and Installation
   All data monitor displays do not switch		Replace BCM. Refer to Removal and Installation .
   All data monitor displays switch		Check intermittent incident. Refer to Intermittent Incident .