FixVault
Home › Isuzu › 1993 › Rodeo LS, RWD, Automatic › Repair and Diagnosis › Electrical › Starter › Testing › Solenoid Tests › Solenoid Return Test

Solenoid Return Test

  1. Connect negative battery lead to terminal 50 (terminal "C" on 3.2L) and ground. See Fig 1 or Fig 2 . Connect battery positive lead to terminal "C" (terminal "M" on 3.2L). Pinion should flutter.
  2. Disconnect lead at terminal 50 (terminal "C" on 3.2L). Pinion should immediately return to stationary position. If pinion does not return to stationary position, replace solenoid.
Fig 1: Testing Solenoid Coil (2.6L)
G90F00989Courtesy of ISUZU MOTOR CO.
Fig 2: Testing Solenoid Pull-In Coil (3.2L)
G91C02024Courtesy of ISUZU MOTOR CO.
About FixVault