Power Window SW Continuity Test (Passenger-Side & Rear SW'S)
Remove suspected switch from door trim panel. Disconnect power window switch harness connector. Using an ohmmeter, check for continuity between specified switch terminals with switch in specified position. See PASSENGER'S SWITCH CONTINUITY . Use illustration for switch terminal identification. See Figure and Figure . If continuity is not as specified, replace switch.
PASSENGER'S SWITCH CONTINUITY
| Application & Position | Check Continuity Between Terminals No. | |
|---|---|---|
| Power Circuit | ||
| DOWN | 2 & 3 | |
| OFF | N/A | |
| UP | 3 & 4 | |
| Ground Circuit | ||
| DOWN | 4 & 5 | |
| OFF | 1 & 2; 4 & 5 | |
| UP | 1 & 2 | |