Cruise Control Module
Disconnect cruise control module connector. Perform all circuit tests at cruise control module wiring harness connector. SeeFig 1 . Ensure ignition switch and cruise control main switch are on. Unless told otherwise, check circuit between specified terminal and ground. See CRUISE CONTROL MODULE table.
CRUISE CONTROL MODULE
| Terminal No. (Circuit)(1) | Test Condition | Specification | ||
|---|---|---|---|---|
| 1 (Cruise Indicator Light) | Ignition & Main Switch On | 12 Volts | ||
| 3 (Vent Valve) | See CRUISE CONTROL ACTUATOR Test | 62-72 Ohms | ||
| 4 (Neutral Sw. - M/T) | Neutral/Not In Neutral | 0 Volts/12 Volts | ||
| 4 (Mode Switch - A/T) | P, R & N/D, 3, 2 & 1 | 0 Volts/12 Volts | ||
| 5 (Battery +) | Ignition & Main Switch On | 12 Volts | ||
| 6 (Set Switch) | Set & Main Switch On | 12 Volts | ||
| 7 (Safety Valve) | See CRUISE CONTROL ACTUATOR Test | 62-72 Ohms | ||
| 8 (Brake Switch) | Switch Depressed/Released | 0 Volts/12 Volts | ||
| 9 (Ground) | n/a | Continuity To Ground | ||
| 10 (Vacuum Pump) | See CRUISE CONTROL ACTUATOR Test | 2 Amps Maximum | ||
| 11 (Resume Switch) | Resume & Main Switch On | 12 Volts | ||
| 12 (Brake Switch) | Switch Released/Depressed | 0 Volts/12 Volts | ||
| 13 (Vehicle Speed Sensor) | Turn Speedometer Cable | Alternating Voltage | ||
|
||||