Cruise Control Module

Disconnect cruise control module connector. Perform all circuit tests at cruise control module wiring harness connector. SeeFig 1 . Ensure ignition switch and cruise control main switch are on. Unless told otherwise, check circuit between specified terminal and ground. See CRUISE CONTROL MODULE table.

Fig 1: Cruise Control Module Wiring Harness Connector Terminals

CRUISE CONTROL MODULE

Terminal No. (Circuit)⁽¹⁾

Test Condition

Specification

3 (Cruise Indicator Light)

Ignition & Main Switch On

12 Volts

4 (Clutch Sw -M/T)

Neutral/Not In Neutral

0 Volts/12 Volts

4 (Mode Sw - A/T)

P, R & N/D, 3, 2 & 1

0 Volts/12 Volts

5 (Vent Valve)

See CRUISE CONTROL ACTUATOR Test

62-72 Ohms

6 (Ground)

n/a

Continuity To Ground

7 (Vacuum Pump)

See CRUISE CONTROL ACTUATOR Test

2 Amps Maximum

9 (Resume Switch)

Resume & Main Switch On

12 Volts

10 (Set Switch)

Set & Main Switch On

12 Volts

14 (Safety Valve)

See CRUISE CONTROL ACTUATOR Test

62-72 Ohms

15 (Battery +)

Ignition & Main Switch On

12 Volts

16 (Brake Switch)

Switch Depressed/Released

0 Volts/12 Volts

19 (Vehicle Speed Sensor)

n/a

⁽²⁾ Voltage

20 (Brake Switch)

Switch Released/Depressed

0 Volts/12 Volts

⁽¹⁾	Pin numbers not listed are not used. Unless told otherwise,check circuit between terminal specified and ground.

⁽²⁾	Test condition or specification not provided by manufacturer. See VEHICLE SPEED SENSOR testing for additional information.