FixVault
Home › Isuzu › 2002 › Rodeo LS, 2.2 D › Repair and Diagnosis › External Pages › Different car › Section 23 (Power-Assisted Steering System) › Power Steering Unit › Reassembly

Power Steering Unit: Reassembly

WARNING: This page is about a different car, the 2002 Isuzu Rodeo Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install mounting rubber and dust cover (If removed).
  2. Install oil line.

    Torque:  13 N.m (113 lb in)

  3. Install tie-rod assembly with tab washer.

    Apply grease to ball joint, install tie-rod and tab washer, then tighten to specified torque.

    Torque:  83 N.m (61 lb ft)

    After tightening, bend tab washer against width across flat of inner ball joint.

  4. Apply a thin coat of grease to the shaft for smooth installation. Then install bellows.
  5. Install band and clip.
  6. Install tie-rod end and tighten lock nut.

    Torque:  98 N.m (72 lb ft)

About FixVault