FixVault
Home › Isuzu › 2003 › Ascender 4.2 S, 4WD › Repair and Diagnosis (Single Page) › Accessories & Equipment › Entertainment Systems › Entertainment System › Repair Instructions › Radio Control Module Replacement › Removal Procedure

Removal Procedure

  1. Remove the right coat hook. Refer to COAT HOOK REPLACEMENT in Interior Trim.
    2. NOTE: In order to avoid damaging the antenna lead connector, follow these guidelines:
    • Use a plastic tool and carefully pry the connector from the window.
    • Do NOT pull on the connector, which may be stuck to the urethane adhesive or the headliner.
  2. Disconnect the control module electrical connector from the stationary glass
  3. Release the rear headliner to roof retainers
  4. Lower the rear of the headliner far enough to access the control module located on the right side of the vehicle
    5. Fig 1: View Of Radio Control Module
    GM728697Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the electrical connector from the control module
  6. Disconnect the coax cable from the control module
  7. Remove the control module from the headliner retaining strips
  8. Remove the control module from the vehicle
About FixVault