FixVault
Home › Isuzu › 2003 › Axiom Base, 4WD › Repair and Diagnosis › External Pages › Different car › Section 17 (HVAC Systems) › Condenser Assembly › Condenser Assembly And Associated Parts › Installation

Condenser Assembly And Associated Parts: Installation

WARNING: This page is about a different car, the 2002 Isuzu Axiom. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install condenser & receiver tank assembly.
    • If installing a new condenser, be sure to add 30cc (1.0 fl. oz.) of new compressor oil to a new one.
    • Tighten the condenser fixing bolts to the specified torque.

      Torque:  6 N.m (52 lb in)

  2. Connect refrigerant line.
    • Tighten the inlet line connector fixing bolt to the specified torque.

      Torque:  15 N.m (11 lb ft)

    • Tighten the outlet line connector fixing bolt to the specified torque.

      Torque:  6 N.m (52 lb in)

    • O-rings cannot be reused. Always replace with new ones.
    • Be sure to apply new compressor oil to the O-rings when connecting the refrigerant line.
  3. Connect pressure switch, ambient sensor and condenser fan connector.
  4. Install head light (R/LH).
  5. Install front side turn signal light (R/LH).
  6. Install horn (R/LH).
  7. Install engine hood front end with engine hood lock & bumper stay.
    • Align the setting mark when installing.
  8. Install condenser air guide.
  9. Install front side bumper retainer (RH).
  10. Install front center bumper retainer.
  11. Install front bumper assembly.
About FixVault