FixVault
Home › Isuzu › 2004 › Axiom Base, 4WD › Repair and Diagnosis › Engine Performance › System › Engine Control System - Diagnostic Information & Procedures › On Vehicle Service › Accelerator Position Sensor Replacement › Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable.
  2. Disconnect the electrical harness from the AP sensor.
    Fig 1: Disconnecting Electrical Harness From AP Sensor
    G02788903Courtesy of ISUZU MOTOR CO.
  3. Remove the AP sensor.
Fig 2: Removing AP Sensor
G02788904Courtesy of ISUZU MOTOR CO.
About FixVault