FixVault
Home › Isuzu › 2004 › Axiom Base, 4WD › Repair and Diagnosis › Engine Performance › System › Engine Control System - Diagnostic Information & Procedures › On Vehicle Service › EEPROM › EEPROM Programming

EEPROM Programming

  1. Set-up - Ensure that the following conditions have been met:
    • The battery is fully charged.
    • The ignition is "ON."
    • The Vehicle Interface Module cable connection at the DLC is secure.
  2. Program The ECM using the latest software matching The vehicle. Refer to Techline equipment user's instructions .
  3. If the ECM fails to program, proceed as follows:
    • Ensure that all ECM connections are OK.
    • Check the Techline equipment for the latest software version.
    • Attempt to program The ECM. If the ECM still cannot be programmed properly, replace the ECM. The replacement ECM must be programmed.
About FixVault