FixVault
Home › Isuzu › 2004 › Axiom Base, RWD › Repair and Diagnosis › Engine Performance › System › Engine Control System - Diagnostic Information & Procedures › On Vehicle Service › Throttle Position (TP) Sensor › Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable.
  2. Disconnect the TPS electrical connector.
  3. Remove the bolts and the TP sensor from the throttle body.
Fig 1: Removing Bolts And TP Sensor From Throttle Body
G02788890Courtesy of ISUZU MOTOR CO.
NOTE: Do not clean the TP sensor by soaking it in solvent. The sensor will be damaged as a result.
About FixVault