FixVault
Home › Isuzu › 2006 › Ascender Limited, 4WD › Repair and Diagnosis › Brakes › Antilock Brake System With Traction Control System & Stability Control System › Repair Instructions › Traction Control Switch Replacement (Buick) › Removal Procedure

Removal Procedure

    IMPORTANT: The console shift lever bezel must be removed prior to removing the traction control switch.
  1. Remove the shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Buick) in Instrument Panel, Gages, and Console.
    2. Fig 1: Traction Control Switch Electrical Connector (Oldsmobile, Buick)
    GM1265379Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector (1) from the switch.
    3. Fig 2: Releasing Traction Control Switch Ring Tabs (Oldsmobile, Buick)
    GM1265389Courtesy of GENERAL MOTORS CORP.
  3. Use a flat-bladed tool to release the ring tabs (1).
    4. Fig 3: Removing/Installing Traction Control Switch Retaining Ring (Oldsmobile, Buick)
    GM1265370Courtesy of GENERAL MOTORS CORP.
  4. Remove the retaining ring from the switch.
    5. Fig 4: Removing/Installing Traction Control Switch (Oldsmobile, Buick)
    GM1265375Courtesy of GENERAL MOTORS CORP.
  5. Remove the switch (1) from the trim plate.
About FixVault