FixVault
Home › Isuzu › 2006 › i-350 › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Power Steering Pump Replacement › Removal Procedure

Removal Procedure

  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 2.8L or Air Cleaner Assembly Replacement in Engine Controls - 3.5L.
  2. Remove the drive belt. Refer to Drive Belt Replacement (without A/C) or Drive Belt Replacement (with A/C) in Engine Mechanical - 2.8L or Drive Belt Replacement (without A/C) or Drive Belt Replacement (with A/C) in Engine Mechanical - 3.5L.
  3. Remove the power steering pump pulley. Refer to Power Steering Pulley Replacement .
  4. Disconnect the oil pressure sensor harness clip from the pump body.
  5. Install a drain pan under the vehicle.
    6. Fig 1: View Of Power Steering Pressure Hoses
    GM1207233Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the power steering pressure hoses from the power steering pump.
    7. Fig 2: View Of Power Steering Pump & Mounting Bolts
    GM1201379Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering pump mounting bolts.
  8. Remove the power steering pump.
About FixVault