Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu Ascender, 2008 GMC Envoy, and 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Radio Antenna Cable Assembly

Courtesy of GENERAL MOTORS CORP.

Install the radio antenna cable assembly to the vehicle.
Pass the antenna cable and grommet assembly through the fender opening.

NOTE: Refer to Fastener Notice .

Install the radio antenna cable assembly retaining screws.
Tighten: Tighten the radio antenna cable assembly screws to 2.8 N.m (25 lb in).
Close the hood.
Install the antenna mast. Refer to Fixed Antenna Mast Replacement .

Fig 2: Identifying Cowl Opening

Courtesy of GENERAL MOTORS CORP.

Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
Install the antenna cable grommet assembly to the cowl opening.
Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement (Front End) .

Fig 3: View Of Radio Antenna Cable To Radio Extension Cable

Courtesy of GENERAL MOTORS CORP.

Install the radio antenna cable (2) to the radio extension cable.
Close the I/P compartment.