FixVault
Home › Isuzu › 2007 › Ascender 4WD › Repair and Diagnosis › External Pages › Different car › Section 470 (Engine Control System & Fuel System - 4.2L - Introduction) › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Envoy and 2009 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Accelerator Pedal Position Sensor
    GM742494Courtesy of GENERAL MOTORS CORP.
  1. Install the APP sensor (2) to vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the APP sensor retaining fasteners (1) and tighten to 10 N.m (89 lb in).
  3. Connect the APP sensor electrical connector.
About FixVault