FixVault
Home › Isuzu › 2007 › i-290 LS, Standard › Repair and Diagnosis › Brakes › Anti-Lock Brake System & Traction Control System › Repair Instructions › Front Wheel Speed Sensor Replacement (4WD) › Installation Procedure

Installation Procedure

    IMPORTANT: Align the wheel speed sensor harness with the reference mark on the wheel hub/bearing assembly.
    Fig 1: View Of Wheel Speed Sensor And Wheel Hub/Bearing Assembly
    GM1790694Courtesy of GENERAL MOTORS CORP.
  1. Position the wheel speed sensor on the wheel hub/bearing assembly.
  2. Carefully press the wheel speed sensor squarely onto the wheel hub/bearing assembly until fully seated against the lip of the wheel hub/bearing assembly housing.
    3. Fig 2: Identifying Wheel Speed Sensor Harness Mounting Bolts
    GM1791020Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Align the wheel speed sensor harness with the reference mark on the steering knuckle.
    NOTE: Refer to Fastener Notice .
  3. Install the brake rotor (2) and wheel hub/bearing assembly to the steering knuckle (3).
  4. Install the wheel hub/bearing bolts (1).

    Tighten:  Tighten the bolts to 125 N.m (92 lb ft).

    5. Fig 3: View Of Speed Sensor Bracket Retaining Bolt
    GM1253304Courtesy of GENERAL MOTORS CORP.
  5. Install the wheel speed sensor harness bracket bolt to the steering knuckle.

    Tighten:  Tighten the bolt to 20 N.m (14 lb ft).

  6. Install the steering knuckle assembly. Refer to Steering Knuckle Replacement (2WD) or Steering Knuckle Replacement (4WD) .
About FixVault