FixVault
Home › Isuzu › 2008 › Ascender LS, RWD › Repair and Diagnosis › Engine Performance › System › Engine Control System & Fuel System - 4.2L - Introduction (2 Of 2) › Repair Instructions › Camshaft Position Sensor Replacement › Removal Procedure

Removal Procedure

    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    GM487648Courtesy of GENERAL MOTORS CORP.
  1. Remove the camshaft position (CMP) sensor electrical connector (1).
  2. Remove the CMP sensor retaining bolt.
About FixVault