FixVault
Home › Isuzu › 2008 › Ascender LS, RWD › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Repair Instructions › Front Seat Belt Replacement › Removal Procedure

Removal Procedure

  1. Remove the seat switch bezel. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement .
  2. Remove the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
    3. Fig 1: Identifying Seat Belt Anchor Nut
    GM752863Courtesy of GENERAL MOTORS CORP.
  3. Remove the seat belt anchor nut from the seat adjuster assembly.
    4. Fig 2: Identifying Seat Belt Bezel Retaining Screw
    GM752860Courtesy of GENERAL MOTORS CORP.
  4. Remove the screw from the front seat back seat belt bezel.
  5. Slide the bezel off the seat belt.
  6. Remove the seat back cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement .
  7. Remove the seat back panel from the seat back frame. Refer to Driver Seat and Passenger Seat Back Cushion Finish Panel Replacement .
    8. Fig 3: View Of Seat Belt At Retractor Bracket
    GM757364Courtesy of GENERAL MOTORS CORP.
  8. Remove the seat belt from the retractor bracket by sliding the seat belt through the slot.
    9. Fig 4: View Of Lower Seat Belt Retractor Retaining Bolt & Nut
    GM757362Courtesy of GENERAL MOTORS CORP.
  9. Remove the lower seat belt retractor retaining bolt and nut.
  10. Remove the retractor assembly by pulling the push pin (2) from the seat back frame.
    11. Fig 5: Locating Seat Belt Retractor Bracket Bolt & Push Pin
    GM757363Courtesy of GENERAL MOTORS CORP.
  11. Remove the seat belt retractor bracket bolt (1) from the bracket and seat back frame.
    12. Fig 6: View Of Seat Belt Retractor & Seat Back Frame
    GM757367Courtesy of GENERAL MOTORS CORP.
  12. Remove the seat belt retractor bracket from the seat back frame.
About FixVault