Alternators & Regulators - MOTOROLA: Overhaul: Reassembly

To reassemble, reverse the disassembly procedure, noting the following. Use a new "O" ring in recess of rear bearing housing. Place stator and coils in marked position, with 3 leads passing back through housing.
When soldering leads, use long-nose pliers as a thermal shunt to protect diode assembly from excessive heat. Use new bearings, as required. Larger inside diameter of short spacer (on front end of spindle) should be next to rotor.

Fig 1: Checking Diodes with a 12-Volt Test Light
Courtesy of NOT AVAILABLE

Connections are shown for positive and negative diodes and diode trio .
If front bearing was removed, use Loctite sealing compound on screw threads and capped holes in retainer plate. Use Loctite on through bolt and nut threads.