Valve Body Assembly
- Install governor pipes into valve body assembly (pipes are interchangeable). Install governor screen assembly (open end first) into governor feed pipe hole in case (hole nearest center of transmission). Install valve body-to-spacer plate gasket.
- Using 2 guide pins, install valve body assembly and governor pipes on transmission. Make sure gasket and spacer plate are not moved out of position, that manual valve is indexed properly with pin on detent lever, and that governor pipes are properly seated in case holes.
- Start control valve body-to-case bolts making sure lead wire clip is installed. Remove guide pins, install detent roller and spring assembly, then install and tighten remaining attaching bolts.