FixVault
Home › Jaguar › 1996 › XJS › Repair and Diagnosis › Engine Performance › Remove, Overhaul & Install › Engine Controls - Remove/Install/Overhaul › Ignition System › Camshaft Position Sensor › Removal (4.0L)

Removal (4.0L)

  1. Disconnect negative battery cable. Camshaft Position (CMP) sensor is located at right front of engine where distributor used to be located. See Figure . Rotate engine until No. 1 piston is at Top Dead Center (TDC).
  2. Verify that the imprinted circle in the metal wheel is centered in the CMP sensor window. See Figure . Mark CMP sensor housing-to-cylinder block location for installation reference. Disconnect CMP sensor connector. Remove CMP sensor retaining bolt. Remove CMP sensor.
About FixVault