Section 34 (Automatic Transmission/Transaxle)
WARNING: This page is about a different car, the 2002 Jaguar S-Type. However, it is still accessible from the selected car via links, so may be relevant.
- Specification
- General Procedure
- Description And Operation
- Transmission Description
- Notes
- Transmission View
- Upshifts
- Downshifts
- Coastdown
- Torque Demand
- Kickdown
- Range Selection
- J-Gate Range Selection
- Traction Control
- Disassembled Views
- Bushings, Bearing and Thrust Washer Locator
- Seals, Rings and Gaskets Location
- Torque Converter
- Geartrain
- Gear Ratio
- Planetary Gearset - Overdrive
- Planetary Gearset - Forward
- Planetary Gearset - Low/Reverse
- Input Shaft
- Output Shaft
- Apply Components
- Hydraulic System
- Main Control
- Transmission Electronic System
- Powertrain Control Module
- Air Conditioning (A/C) Clutch
- Brake Pedal Position (BPP) Switch
- Engine Coolant Temperature (ECT) Sensor
- Electronic Ignition (EI) System
- Intake Air Temperature (IAT) Sensor
- Mass Air Flow (MAF) Sensor
- Transmission Control Switch (TCS)
- Throttle Position (TP) Sensor
- Digital Transmission Range (TR) Sensor
- Turbine Shaft Speed (TSS) Sensor
- Output Shaft Speed (OSS) Sensor
- Intermediate Shaft Speed (ISS) Sensor
- Pressure Control Solenoids (PCA, PCB, PCC)
- Torque Converter Clutch (TCC) Solenoid
- Shift Solenoids- (SSA, SSB, SSC, SSD)
- Transmission Fluid Temperature (TFT) Sensor
- Reverse Pressure (RP) Switch
- Transmission Description
- Diagnosis and Testing
- Diagnostic Strategy
- Preliminary Inspection
- Overview
- Notes
- Know and Understand the Concern
- Verification of Condition
- Determine Customer Concern
- Check Fluid Level and Condition
- High Fluid Level
- Low Fluid Level
- Adding Fluid
- Fluid Condition Check
- Road Testing Vehicle
- Shift Point Road Test
- Shift Speeds 3.0 Liter
- Shift Speeds 4.0 Liter
- Torque Converter Diagnosis
- Torque Converter Operation Test
- Diagnostics
- Diagnostic Flow Chart
- Visual Inspection
- Shift Linkage Check
- Check TSBs
- Carry Out On-Board Diagnostics (KOEO, KOER)
- Transmission Drive Cycle Test
- After On-Board Diagnostics
- Before Pinpoint Tests
- Diagnostic Trouble Code Charts
- Transmission Connector Layouts
- Shift Solenoid Operational Charts
- Pinpoint Tests
- PINPOINT TEST G61347p1 : P0705, P0708-Digital TR sensor circuit TR3A open
- PINPOINT TEST G61347p2 : P0712-157°C (315°F) indicated TFT sensor circuit grounded
- PINPOINT TEST G61347p3 : P0713-40°C (-40°F) indicated TFT sensor circuit open
- PINPOINT TEST G61347p4 : P0715, P0717, P0718-Insufficient input from turbine shaft speed sensor, turbine shaft speed sensor signal intermittent
- G61347t6 : CHECK RESISTANCE OF TURBINE SHAFT SPEED SENSOR
- G61347t7 : CHECK THE GROUND SUPPLY TO THE TURBINE SHAFT SPEED SENSOR
- G61347t8 : CHECK THE CONTINUITY OF THE TURBINE SHAFT SPEED SENSOR GROUND CIRCUIT
- G61347t9 : CHECK THE CONTINUITY OF THE TURBINE SHAFT SPEED SENSOR SIGNAL CIRCUIT
- G61347t10 : CHECK THE TURBINE SHAFT SPEED SENSOR SIGNAL CIRCUIT FOR SHORT TO GROUND
- PINPOINT TEST G61347p5 : P0720, P0721, P0722-Insufficient input from OSS sensor
- G61347t11 : CHECK RESISTANCE OF THE OUTPUT SPEED SENSOR
- G61347t12 : CHECK THE GROUND SUPPLY TO THE OUTPUT SPEED SENSOR
- G61347t13 : CHECK THE CONTINUITY OF THE OUTPUT SPEED SENSOR GROUND CIRCUIT
- G61347t14 : CHECK THE CONTINUITY OF THE OUTPUT SPEED SENSOR SIGNAL CIRCUIT
- G61347t15 : CHECK THE OUTPUT SPEED SENSOR SIGNAL CIRCUIT FOR SHORT TO GROUND
- PINPOINT TEST G61347p6 : P0741**, P0743* TCC solenoid circuit failure during on-board diagnostic
- PINPOINT TEST G61347p7 : P0745, P1746**, P1747**, P1760-PCA solenoid circuit open
- PINPOINT TEST G61347p8 : P0731**, P0732**, P0733**, P0734**, P0750*, P1714-SSA solenoid circuit failure
- PINPOINT TEST G61347p9 : P0731**, P0732**, P0733**, P0734**, P0755*, P1715-SSB solenoid circuit failure
- PINPOINT TEST G61347p10 : P0731**, P0732**, P0733**, P0734**, P0760*, P1716-SSC solenoid circuit failure
- PINPOINT TEST G61347p11 : P0731**, P0732**, P0733**, P0734**, P0765*, P1717-SSD solenoid circuit failure
- PINPOINT TEST G61347p12 : P0775, P0779, P1788**-PCB Solenoid circuit failure, shorted circuit
- PINPOINT TEST G61347p13 : P0791, P0794-Intermediate shaft speed sensor signal noisy
- G61347t41 : CHECK RESISTANCE OF THE INTERMEDIATE SHAFT SPEED SENSOR
- G61347t42 : CHECK THE GROUND SUPPLY TO THE INTERMEDIATE SHAFT SPEED SENSOR
- G61347t43 : CHECK THE CONTINUITY OF THE INTERMEDIATE SHAFT SPEED SENSOR GROUND CIRCUIT
- G61347t44 : CHECK THE CONTINUITY OF THE INTERMEDIATE SHAFT SPEED SENSOR SIGNAL CIRCUIT
- G61347t45 : CHECK THE INTERMEDIATE SHAFT SPEED SENSOR SIGNAL CIRCUIT FOR SHORT TO GROUND
- PINPOINT TEST G61347p14 : P0795, P0796**, P0797**, P0799-PCC solenoid circuit failure, shorted circuit
- PINPOINT TEST G61347p15 : P0840-Reverse pressure switch circuit input signal failed.
- PINPOINT TEST G61347p16 : P1703-BPP switch circuit failed
- G61347t52 : CHECK GEARSHIFT INTERLOCK RELAY AUDIBLY
- G61347t53 : CHECK THE VOLTAGE SUPPLY TO THE GEARSHIFT INTERLOCK RELAY
- G61347t54 : CHECK THE VOLTAGE SUPPLY TO THE GEARSHIFT INTERLOCK RELAY
- G61347t55 : CHECK THE BPP SWITCH VOLTAGE SUPPLY TO THE GEARSHIFT INTERLOCK RELAY
- G61347t56 : CHECK THE BPP SWITCH VOLTAGE SUPPLY CIRCUIT
- G61347t57 : CHECK THE BPP SWITCH VOLTAGE SUPPLY CIRCUIT
- G61347t58 : CHECK THE BPP SWITCH
- G61347t59 : CHECK THE CONTINUITY OF THE J GATE ASSEMBLY BPP SIGNAL CIRCUIT
- PINPOINT TEST G61347p17 : P1711, P1713, P1718-TFT out of on-board diagnostic range, no change in TFT - low range, no change in TFT - high range.
- G61347t60 : CHECK RESISTANCE OF THE FLUID TEMPERATURE SENSOR
- G61347t61 : CHECK THE GROUND SUPPLY TO THE FLUID TEMPERATURE SENSOR
- G61347t62 : CHECK THE CONTINUITY OF THE FLUID TEMPERATURE SENSOR GROUND CIRCUIT
- G61347t63 : CHECK THE CONTINUITY OF THE FLUID TEMPERATURE SENSOR SIGNAL CIRCUIT
- G61347t64 : CHECK THE FLUID TEMPERATURE SENSOR SIGNAL CIRCUIT FOR SHORT TO GROUND
- PINPOINT TEST G61347p18 : P0814, P1704, P1705-J-GATE circuit input signal failed.
- G61347t65 : CHECK FOR IGNITION FEED TO J-GATE
- G61347t66 : CHECK FOR GROUND SUPPLY TO THE J-GATE
- G61347t67 : CHECK DIGITAL TR WITH J-GATE SELECTOR IN THE PARK POSITION
- G61347t68 : CHECK DIGITAL TR WITH J-GATE SELECTOR IN THE NEUTRAL POSITION
- G61347t69 : CHECK THE J-GATE P POSITION OUTPUT FROM CA41 PIN 5
- G61347t70 : CHECK THE J-GATE P POSITION OUTPUT FROM CA41 PIN 4
- G61347t71 : CHECK THE J-GATE P POSITION OUTPUT FROM CA41 PIN 3
- G61347t72 : CHECK THE J-GATE R POSITION OUTPUT FROM CA41 PIN 5
- G61347t73 : CHECK THE J-GATE N POSITION OUTPUT FROM CA41 PIN 4
- G61347t74 : CHECK THE J-GATE 3 POSITION OUTPUT FROM CA41 PIN 3
- PINPOINT TEST G61347P19 : Solenoid mechanical failure
- Special Testing Procedures
- Engine Idle Speed Check
- Line Pressure Test
- Line Pressure Diagnosis Chart
- Stall Speed Test
- Leakage Inspection
- External Sealing
- Fluid Leakage in Torque Converter Area
- Leak Check Test
- Leak Check Test With Ultraviolet Light
- Transmission Fluid Cooler
- Transmission Fluid Cooler Flow Test
- Transmission Fluid Cooler Tube Replacement
- Diagnosis by Symptom
- Preliminary Inspection
- Diagnostics
- Diagnostic Strategy
- Removal
- Installations
- In Vehicle Repair