FixVault
Home › Jaguar › 2000 › XJ8 Base › Repair and Diagnosis › External Pages › Different car › Section 171 (Engine System - General Information) › Engine System - General Information › Engine - Diagnostic Procedures › Compression Test › Check The Compression Pressure

Check The Compression Pressure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Jaguar S-Type, 2007 Jaguar S-Type, 2006 Jaguar S-Type, 2005 Jaguar S-Type, and 2004 Jaguar S-Type. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: On manual transmissions shift the transmission into neutral. On automatic transmission vehicles, select "P". Failure to follow these instructions may result in personal injury.
  1. Remove the fuel pump relay.
  2. Start the engine - the engine will start, run for a few seconds then stall.
  3. Remove the spark plugs.
  4. Install the compression tester.
  5. Install an auxiliary starter switch in the starting circuit. With the ignition switch OFF, using the auxiliary starter switch, crank the engine a minimum of five compression strokes and record the highest reading. Note the approximate number of compression strokes required to obtain the highest reading.
  6. Repeat the test on each cylinder, cranking the engine approximately the same number of compression strokes.
  7. Install the components in reverse order, observing the specified tightening torques.
  8. Reset the ECM fault memory.
About FixVault