FixVault
Home › Jaguar › 2002 › XJR Base › Repair and Diagnosis › External Pages › Different car › Section 49 (External Control) › Removal & Installation › Selector Lever Indicator Assembly › Removal

Selector Lever Indicator Assembly: Removal

WARNING: This page is about a different car, the 2002 Jaguar XKR and 2001 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove battery cover and disconnect ground cable from battery terminal. Refer to BATTERY DISCONNECTION PROCEDURE .
  2. Remove the selector lever knob. See TRANSMISSION SELECTOR LEVER KNOB .
  3. Remove the J-gate surround. See SELECTOR LEVER GATE FINISH PANEL .
  4. Remove the console finisher veneer panel. See FLOOR CONSOLE FINISH PANEL .
  5. Remove the selector indicator module screws.
    Fig 1: Removing Selector Indicator Module Screws
    G00378928Courtesy of JAGUAR CARS, INC.
  6. Remove the selector indicator module.
    1. Free the D to 4 switch harness multiplug from the mounting bracket and disconnect the multiplug.
    2. Displace the P switch multiplug from the mounting bracket.
    3. Route the D to 4 harness from under the P switch harness.
    Fig 2: Disconnecting & Connecting Selector Module Electrical Connectors
    G00378929Courtesy of JAGUAR CARS, INC.
About FixVault