DTC Index

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00.

NOTE: If the control module is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval program is in operation, prior to the installation of a new module.

NOTE: The DTC Index shows information for DTCs that could be logged in the Driver Door Module (DDM) or Passenger Door Module (PDM). For diagnosis and testing information for: Driver/Passenger Seat module. Refer to Seats article. Information and Entertainment module. Refer to Audio System article. Remote Keyless Entry module. Refer to Locks, Latches and Entry Systems article.

NOTE: Generic scan tools may not read the codes listed, or may read only five digit codes. Match the five digits from the scan tool to the first five digits of the seven digit code listed to identify the fault (the last two digits give additional information read by the manufacturer approved diagnostic system).

NOTE: When performing electrical voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places, and with an up-to-date calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.

NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.

NOTE: Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.

NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.

DTC	Description	Possible Cause	Action
B109C15	Front Courtesy Light	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test front courtesy light circuit for short to power or open circuit
B109D11	Front Courtesy Light	Short to ground	Refer to the appropriate system wiring diagrams article and test front courtesy light circuit for short ground
B10EB11	Driver door double locking motor	Short to ground	Refer to the appropriate system wiring diagrams article and test driver door double locking motor circuit for short ground
B10EB15	Driver door double locking motor	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test driver door double locking motor circuit for short to power or open circuit
B10EC11	Passenger door double locking motor	Short to ground	Refer to the appropriate system wiring diagrams article and test passenger door double locking motor circuit for short ground
B10EC15	Passenger door double locking motor	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test passenger door double locking motor circuit for short to power or open circuit
B110811	Driver door central locking motor	Short to ground	Refer to the appropriate system wiring diagrams article and test driver door central locking motor circuit for short ground
B110815	Driver door central locking motor	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test driver door central locking motor circuit for short to power or open circuit
B110911	Passenger door central locking motor	Short to ground	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B110915	Passenger door central locking motor	Short to power or open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B116311	Left Mirror Heater Output short to ground	Short to ground	Refer to the appropriate system wiring diagrams article and test left mirror heater output circuit for short to ground
B116315	Left Mirror Heater Output short to power	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test left mirror heater output circuit for short to power or open circuit
B116411	Right Mirror Heater Output short to ground	Short to ground	Refer to the appropriate system wiring diagrams article and test right mirror heater output circuit for short to ground
B116415	Right Mirror Heater Output short to power	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test right mirror heater output circuit for short to power or open circuit
B116511	Left Front Puddle Lamp Output short to ground	Short to ground	Refer to the appropriate system wiring diagrams article and test left front puddle lamp output circuit for short to ground
B116515	Left Front Puddle Lamp Output open load or short to power	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test left front puddle lamp output circuit for short to power or open circuit
B116611	Right Front Puddle Lamp Output short to ground	Short to ground	Refer to the appropriate system wiring diagrams article and test right front puddle lamp output circuit for short to ground
B116615	Right Front Puddle Lamp Output open load or short to battery	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test right front puddle lamp output circuit for short to power or open circuit
B117E72	Front Power Window up	Actuator stuck open	Install a new DDM/PDM, refer to DTC Index
B117E73	Front Power Window up	Actuator stuck closed	Install a new DDM/PDM, refer to DTC Index
B117F72	Front Power Window down	Actuator stuck open	Install a new DDM/PDM, refer to DTC Index
B117F73	Front Power Window down	Actuator stuck closed	Install a new DDM/PDM, refer to DTC Index
B118929	Front Window Position Sensor	Signal invalid	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B118A29	Rear Window Position Sensor	Signal invalid	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B1A9411	Driver Mirror	Short to ground	Refer to the appropriate system wiring diagrams article and test driver mirror fold motor circuit for short to ground
B1A9415	Driver Mirror	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test driver mirror fold motor circuit for short to power or open circuit
B1A9511	Passenger Mirror	Short to ground	Refer to the appropriate system wiring diagrams article and test passenger mirror fold motor circuit for short to ground
B1A9515	Passenger Mirror	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test passenger mirror fold motor circuit for short to power or open circuit
B1A9883	LIN Bus Circuit #1	Value of signal protection calculation incorrect	Refer to the appropriate system wiring diagrams article and test LIN circuit between driver switch pack and DDM for short/open circuits, clear DTC and re-test. If DTC remains install a new switch pack. Refer to Window Control Switch article.
B1A9886	LIN Bus Circuit #1	Signal Invalid	Refer to the appropriate system wiring diagrams article and test LIN circuit between driver switch pack and DDM for short/open circuits, clear DTC and re-test. If DTC remains install a new switch pack. Refer to Window Control Switch article.
B1A9887	LIN Bus Circuit #1	Missing Message	Refer to the appropriate system wiring diagrams article and test LIN circuit between driver switch pack and DDM for short/open circuits, clear DTC and re-test. If DTC remains install a new switch pack. Refer to Window Control Switch article.
B1C0911	Driver Left/Right Mirror Motor Circuit	Short to ground	Refer to the appropriate system wiring diagrams article and test driver left/right mirror motor circuit for short to ground
B1C0915	Driver Left/Right Mirror Motor Circuit	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test driver left/right mirror motor circuit for short to power or open circuit
B1C1011	Driver Up/Down Mirror Motor Circuit	Short to ground	Refer to the appropriate system wiring diagrams article and test driver up/down mirror motor circuit for short to ground
B1C1015	Driver Up/Down Mirror Motor Circuit	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test driver up/down mirror motor circuit for short to power or open circuit
B1C1111	Passenger Left/Right Mirror Motor Circuit	Short to ground	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B1C1115	Passenger Left/Right Mirror Motor Circuit	Short to power or open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B1C1211	Passenger Up/Down Mirror Motor Circuit	Short to ground	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B1C1215	Passenger Up/Down Mirror Motor Circuit	Short to power or open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B1C1311	Driver Up/Down Mirror Motor Feedback Circuit	Short to ground	Refer to the appropriate system wiring diagrams article and test driver up/down mirror motor feedback circuit for short to ground
B1C1315	Driver Up/Down Mirror Motor Feedback Circuit	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test driver up/down mirror motor feedback circuit for short to power or open circuit
B1C1411	Driver Left/Right Mirror Motor Feedback Circuit	Short to ground	Refer to the appropriate system wiring diagrams article and test driver left/right mirror motor feedback circuit for short to ground
B1C1415	Driver Left/Right Mirror Motor Feedback Circuit	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test driver left/right mirror motor feedback circuit for short to power or open circuit
B1C1511	Passenger Up/Down Mirror Motor Feedback Circuit	Short to ground	Refer to the appropriate system wiring diagrams article and test passenger up/down mirror motor feedback circuit for short to ground
B1C1515	Passenger Up/Down Mirror Motor Feedback Circuit	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test passenger up/down mirror motor feedback circuit for short to power or open circuit
B1C1611	Passenger Left/Right Mirror Motor Feedback Circuit	Short to ground	Refer to the appropriate system wiring diagrams article and test passenger left/right mirror motor feedback circuit for short to ground
B1C1615	Passenger Left/Right Mirror Motor Feedback Circuit	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test passenger left/right mirror motor feedback circuit for short to power or open circuit
C1B1411	Sensor Supply #1	Short to ground	Refer to the appropriate system wiring diagrams article and test window sensor supply circuit for short to ground
C1B1415	Sensor Supply #1	Short to power or open circuit	Refer to the appropriate system wiring diagrams article and test window sensor supply circuit for short to power or open circuit
U001000	Medium speed CAN communication Bus	Medium speed CAN communication Bus	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
U014000	Lost communication with CJB	Logged when subscribed CAN message missing from CJB	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
U020800	Lost communication With Driver Seat Module (DSM)	Missing message	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
U030000	Internal control module software incompatibility	Invalid configuration message is received	Re-configure the RJB using the manufacturer approved diagnostic system. Clear the DTC and retest. If the DTC is still logged suspect the DDM/PDM, refer to DTC Index
U200224	Switch	Signal stuck high	Clear DTC and re-test. If DTC remains, install a new passenger side window switch
U201011	Switch illumination	Circuit short to ground	Carry out CAN network tests using the manufacturer approved diagnostic system
U201012	Switch illumination	Circuit short to battery	Carry out CAN network tests using the manufacturer approved diagnostic system
U201208	Car Configuration Parameter(s)	Bus signal/message failures	Cycle the ignition status and re-test. If DTC remains, re-configure the RJB using the manufacturer approved diagnostic system
U201324	Switch Pack	Signal stuck high	Clear DTC and re-test. If DTC remains, install a new driver side window switch pack. Refer to Window Control Switch article.
U201444	Control module hardware	Data Memory Failure	Install a new DDM/PDM, refer to DTC Index
U210000	Initial configuration not complete	No sub type information	Re-configure the DDM/PDM using the manufacturer approved diagnostic system
U300049	Control module	Internal electronic failure	Install a new DDM/PDM, refer to DTC Index
U300255	Vehicle Identification Number (VIN)	Not configured	Re-configure the relevant module as new using the manufacturer approved diagnostic system and re-test. If DTC remains install a new module, refer to DTC Index
U300281	Vehicle Identification Number (VIN)	Vehicle/component mis-match. Corrupt VIN data being transmitted, module previously installed to other vehicle	Install original module, check for DTCs and refer to DTC Index
U300362	Battery voltage	Mis-match of battery voltage, of 2 volts or lower, between DDM/PDM and RJB	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system