FixVault
Home › Jaguar › 2007 › XJ8 Base › Repair and Diagnosis › External Pages › Different car › Section 168 (MULTIFUNCTION Electronic Modules) › Multifunction Electronic Modules › Remote Keyless Entry (RKE) Module - Removal and Installation › Removal

Remote Keyless Entry (RKE) Module - Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This module is installed on the inside of the RH A-pillar above the footwell and does not change with the hand of drive.
  1. Remove the cover and disconnect the battery ground cable. Refer to Specifications article.
    GJ0009595Courtesy of JAGUAR CARS, INC.
    2. CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
  2. Remove the RH side footwell trim panel.
    • Remove the 3 clips.
    GJ0009596Courtesy of JAGUAR CARS, INC.
  3. Remove the keyless entry module.
    • Remove the 2 Torx screws.
    • Disconnect the 5 electrical connectors.
About FixVault