FixVault
Home › Jaguar › 2007 › XK8 2D Convertible › Repair and Diagnosis › Electrical › Starter › Starting System › Starting System (4.2L) › Start Control Unit - Removal and Installation › Installation

Start Control Unit - Removal and Installation: Installation

  1. Install the keyless start control module.
    • Connect the electrical connector.
    • Install the Torx screws.
  2. Install the keyless start control module trim cover.
    • Install the Torx screws.
  3. Install the floor console side panel trim.
    • Carefully align and secure the clips.
    • Tighten the Torx screws to 6 Nm (4 lb.ft).
    • Install the opposite hand.
  4. Install the floor console rear panel.
    • Align the lugs and secure the clips.
  5. Install the floor console veneer trim panel. Refer to Floor Console Finish Panel article.
  6. Install the rear seat armrest. Refer to Rear Seat Armrest article.
  7. Connect WDS to the vehicle and configure a new module.
About FixVault